MINGDA 3D Printer Magician X,Newest Auto-Leveling FDM 3D Printers with Cortex-M4 Chip, High-Performance Motherboard and TMC Ultra Silent Print, 230x230x260mm Large Build Plate

Product Information

This mechanism presses against the filament, and by holding it, you create space for the filament to pass thru. Some mention that it works well and the printing quality is excellent, while others say that the first printer did not work at all, it's a waste of money if it' s not usable, and the sd card reader stopped working. The only thing with glass beds is they do need a really really good clean sometimes it's just how they come from the manufacture. It just took a bit of exploration and experimentation to determine what all the touchscreens really meant.

Once removed from the box, you’ll need to set the gantry into the main chassis, and bolt it from underneath. I did mention the tool-box lid was damaged on receipt, there was a tiny split and a good bend on the hinge side of the lid, I used my heat gun to gently heat the lid up and managed to straighten it up, the tiny split is barely noticeable now and the lid is fully serviceable! It’s good advice, and I’ve gotten into the habit of pushing filament forward only with any direct drive printer. Initially I had chosen an Ender 3 S1 profile, but the results were not good (bad shrinkage) so I went with a new blank profile for which I only defined the size of the printer (on a Marlin base).

The quality of the finished model is quite clean, with smooth curves and clean joints that allow for easy bending and posing (again using. The printer itself seems sturdy, was super easy to put together, and has an intuitive touch screen interface. Once in place, you then move to the “Extrude” menu on the touchscreen, which is hidden under the “Menu” item. There are other small touches that make the Magician X fun to use, it has belt tension knobs when you need to tweak the X and Y belt tightness, a frame that cradles the glass plate with just one clip, and a handle on top when you need to move it around.

I've had some mild luck bringing the bed temp up to 85c, nozzle at 200, but the filament still isn't laying down uniformly.An increasingly common feature we're seeing on 3D printers is the LCD screen; this enables you to adjust the printer settings and access prints from an SD card or USB stick.