Braun Series 9 9390cc Latest Generation Electric Shaver, Clean&Charge Station, Leather Case, Silver

Product Information

Again, I cannot say anything with certainty right now, but I would be really surprised if these new models were better than the current Series 7 and Series 5, respectively. Since you’re using the station, a lubrication problem is unlikely, but if you can get it, I highly recommend the Remington Shaver Saver spray. The benefit of using the cleaning dock is convenience and getting it charged in the same place as cleaning. For context regarding my beard type: hair primarily grows on the chin, moustache and jaw area with zero growth around the neck. When they go up they will push on some tiny plastic rockers on the cassette which retract the outermost foils and also the adjacent cutters but only a bit.

I guess if I leave the shaver in an always plugged in charger I’ll seldom, if ever, will see any number on the display. In fact, you only need the shaver to run a few seconds before it triggers a cleaning session when you drop it in the station, whether you actually shaved with it or not. It was the first time I was going to spoil myself with what I thought was the ultimate electric razor. A 32-bit MCU can process a lot of data at a much faster rate, so it may be better at assessing the density of the beard.I’ve owned quite a few Series 9 shavers from all generations and mine have stood the test of time very well.

It sounds great, but it is not something that I can notice when using it, which may not mean it’s not functioning in that manner. the easiest way to check this is by locking the head in the next to last position and than to push the pusher gently inwards with a small screwdriver. Sent it in for the 2nd time, got it back last week, shaved once and today I wanted to use it again but it’s just completely dead. Overall, cleaning the Series 9 is generally pretty straightforward, whether you use the cleaning station or you do it yourself.Although the shaving head seems to become warmer than on the series 7, it is still more comfortable. Trying to reverse engineer Braun’s solution, while also getting the required electrical conductivity of the fluid and the cleaning and lubricating properties can be tricky. If you’re on a tighter budget, shave daily/every other day and you have a light to medium beard, the Arc 3 should be good enough. Just don’t use it right before shaving — the foils should be completely dry, so make sure you allow them enough time to dry. In my case, it’s the one that gives me the closest shave on the moustache and chin where my beard is really dense and thick.

This was when I wondered how well the two cutters (not the foils) were actually doing the job they should do. Again, they aren’t major and in my opinion you shouldn’t pay too much attention as the shaving performance is identical (they also use the same shaving heads). It could do the job well and it was a close shave eventually, but the issue was the movable head section that also locks just kept moving out of place.Cerave products are really good and you should generally stick to gentle, hydrating balms unless a dermatologist recommends you otherwise. Again, really appreciate your information on these “new” models, the comparison with existing Series 3 is very helpful. Also, the head locking switch must be in the unlocked position, otherwise, the shaver may not sit properly inside the station.