Solvent Weld White 40mm (43mm) Waste Pipe Swept Bend - Pack of 2

Product Information

For your kitchen depending on the length of pipe run 40mm should be ok although I prefer 50mm and reduce the branches top each appliance. Cant you just lift up the gulley grating and turn it around and then cut a slight crescent in the solid plastic to take the edge of the 45deg bend ? Attach the waste pipe to the floor, ceiling or wall using a pipe clip or fit them around bends and corners with a pipe bend at 90°, 92.

Keep your pipework smooth with our range of solvent weld pipes and connectors, suitable for both domestic and commercial plumbing installations. New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging .My outside waste pipe from the kitchen sink has a 90degree joint that has cracked and causing the waste to leak before reaching the main drain. We will not accept any liability for the delays caused by third party contractors waiting for goods to be delivered. In contrast, waste pipe fittings made from polypropylene and polyethene will not break down or bond when exposed to solvents.

Most purchases from business sellers are protected by the Consumer Contract Regulations 2013 which give you the right to cancel the purchase within 14 days after the day you receive the item. Osma have kept all the same part numbers but the new are not compatible with the old except via a universal adaptor. Our comprehensive variety includes everything from solvent weld overflow pipes to knuckle bends, straight couplers and saddle pipe brackets in a range of colours. I guess firstly, to remove the joint i think i need to saw off the pipe at the joint which would result in a smaller pipe out of the wall. If the item comes direct from a manufacturer, it may be delivered in non-retail packaging, such as a plain or unprinted box or plastic bag.

I naively thought a simple replacement would be suitable however since found that the joint is solvent weld and has an outside diameter of 43mm rather the standard 40mm. Where there is a manufacturers warranty on the product we can help you organise the warranty replacement of that item, in some cases you may have to contact the manufacturer directly. Once the fish have been purchased and left our premises we will not accept any responsibility for the fish. The system includes various branches, bends, adaptors and boss fittings allowing maximum efficiency and versatility during installation. Increase the length or join solvent weld pipe together with Magicflex solvent elbows and connectors from Wirquin.