Anker Soundsync Bluetooth Receiver for Music Streaming with Bluetooth 5.0, 12-Hour Battery Life, Handsfree Calls, Dual Device Connection, for Car, Home Stereo, Headphones, Speakers

Product Information

so the Bluetooth blue light will be blinking on that device) If not trigger Bluetooth pairing on that PowerConf device as well. There are receivers only or both transmitter/receivers if you need to do something else, but I knew this going in, and this is exactly what I wanted. But mostly consist of 2 second presses of the single button on the device and adjusting it from receiver to transceiver modes via the sliding switch on the side. Only the device, a charge cord, an aux cord, and a double-male aux plug were included in the packaging.

As long as your guitar amplifier has a line-in port, this gadget should function if you want to play music from a device like an iPhone or iPad through it. I’ve tried holding the multi button for over 10 seconds to reset it just in case, tried putting it in pairing mode WITH the aux cable attached… Nada.It’s a simple little gadget that solves what, for me at this juncture in my life, is a critical void; Bluetooth audio. The Bluetooth options don’t end with a car either, an older household speaker system can be modernised to accept Bluetooth tech too with this device.

Initial setup at home was a bit tricky as there is no interface and it will connect to the first discoverable Bluetooth device, but no problems once I got that straightened out. bc I only got this to transmit my phone’s audio to my car’s stereo, where you plug the transmitter into the aux port? I’d really like to hide the unit in the back so it kind of defeats the purpose if I need to interact with it every time I want to use it requiring me to have it in the front.For verdicts, scoops, news and analysis from the team, delivered direct to your inbox, subscribe to the CAR newsletter. The lights turn green then back to blue about the 10 sec mark; but no connection to my Soundbar; like it used to. I also was interested in seeing whether the Soundsync A3341 could take TV audio and broadcast it to my Bluetooth headset. home theater system out in my barn and I haven’t used in a few years because I can’t connected to my phone or tablet. You can prove this now if you want to, while it’s flashing connect some bluetooth headphones to it and find a AUX source.

As has been mentioned before, the SoundSync in my car has much lower volume from my Samsung Galaxy S6 phone on Bluetooth than I experience using an Aux cable connected directly to the phone. Read more about the condition New: A brand-new, unused, unopened and undamaged item in original retail packaging (where packaging is applicable).I was looking at this and wondered if I would have to keep pluggging it in and out depending on if I wanted the sound to come from the tv or headphones via the Bluetooth. My iPhone immediately recognized the Soundsync A3341, and I was soon hearing music through the speakers without any distortion or drop-out.

If Soundsync freezes, press and hold the multi-function button, insert the Micro USB cable to start charging, then restart Soundsync.

There's a hundred equivalents from competitors that cost significantly less and usually offer more features such as a newer version of Bluetooth and/or the ability to receive as well as transmit. I then turned the Soundsync A3341 on and pressed the the multi-function power button for two seconds. I’m a night owl too sleep is a waste of time life is too short, I’ll sleep when I’m dead😎 Don’t let that stereo go to waste loud music is good for the soul. Listening to 200 Mac DeMarco songs feels a lot easier when you don’t have to hard-wire speakers to a computer. This item is designed as a bluetooth transmitter, therefore, this needs to be plugged into an AUX output of a device so that your headphones or speakers (with BT capability) can pair with your device without Bluetooth function.