12pcs Pool Plug Stopper Compatible with Bestway & Intex Swimming Pool Wall Plugs Replacement Parts Above Ground Swimming Pool Filter Strainer Plug Stopper for Inflatable Pool Accessories

Product Information

EN60335-2-41 TEST standard requires the filter pump must be vertically fixedon ground or a certain pedestal made of wood or concrete before use. There should be two holes 9mm in diameter on the pedestal, the space between which should be 163mm. Put filter pump on the pedestal and fix them together by fasten the bolts and nuts. All the pedestal parts should weigh over 18kgs at least to prevent the pump from accidental falling. Installer need to fill in the balance of information and give it to the pool owner, to be kept with other important pool related documents. Before inserting plug into a power outlet, make sure the current rate of the power outlet is suitable for the pump.

The pump is not intended to be bonded to the equipotential bonding grid. DO NOT BURY CORD. Locate cord to minimize abuse from lawn mowers, hedge trimmers, and other equipment. When installing and using this electrical equipment, basic safety precautions should always be followed, including the following:Each LED indicator represents 2 hours of working time. You can push the Set Working Hours Button to adjust the desired time. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Winterizing instructions. Dry the suction fittings completely ,and store the product in a dry room at a storage temperature of 15 ℃; ~ 40 ℃. This product is provided with a ground-fault circuit-interrupter. If replacement of the plug is needed, use only identical replacement parts. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Seventh step: fill the bottom part with the new sand until it reaches the mark between low and high marked on the hub. Using the pump with an unmatched electrical supply is dangerous and will result in catastrophic failure of pump. Fifth step: open the metal ring in the middle of the tank body and open the upper part of the tank. Sixth step: take out all old sand from the tank and rinse the bottom part with a garden hose to be sure it is clean. The use of adhesives or other attachment methods that prevent access to suction piping or SOFA components requiring periodic servicing is prohibited. IMPORTANT: Certain types of hard grass can grow through the liner, as can aggressive bushes/plants by the sides or through the pool. If this happens, it cannot be considered a manufacturer problem.This pump is for use with storable pools only. Do not use with permanently-installed pools. A storable pool is constructed so that it is capable of being readily disassembled for storage and reassembled to its original integrity. A permanently-installed pool is constructed in or on the ground or in a building such that it cannot be readily disassembled for storage.