Lifetree Window Film Privacy: Privacy Film for Glass Windows Non-Adhesive No Glue Window Film Reeded Glass Decorative Patterned Static Cling Films for Home 44.5 * 200cm

Product Information

Wetting solution is the secret ingredient to a smooth, seamless installation. Make a solution by adding 8-10 drops of a mild, non-moisturizing dish detergent (Dawn or Joy; do not use hand soap) to a 32-oz. spray bottle filled with clean water (adjust ratio for smaller or larger bottles). More soap may be needed when applying film to acrylic surfaces. If you have hard water, consider using filtered or bottled water, to prevent mineral deposits under the film. Mix well.

This designer-look is easier than ever to achieve at home, thanks to Purlfrost’s easy application. Once your made-to-measure reeded glass film arrives, spray the window and film with water and apply, making sure to smooth out any air bubbles and wrinkles – it’s as simple as that. The possibilities are endless; from internal and external windows to kitchen cabinets, shower screen through to a freestanding cupboard or even a glass coffee table.Tools: Scissors, Tape Measure, Razor Knife, Ruler, Plastic Card Squeegee, Spray Bottle, and Paper Towel. We have both DIY and fully installed options for our reeded window film so why not give us a call to explore the possibilities? Before you do any actual cutting, you should consider where to place the seam on the window. You will usually have options when deciding: do you want it vertical or horizontal? Higher or lower? It may depend on the width of the roll you are working with, but generally you’ll want to place it where it is least noticeable. If you have tall windows, placing it at the top will make it harder to see. If it is darker at the bottom or people tend to look toward the top more often, then placing it at the bottom will be the best method. Give yourself enough space to work. You will need enough flat surface to lay out the film for measuring, cutting, marking and prep. Do not run a fan near the film or glass surface during installation. This can cause dust and debris to blow onto your film and become trapped. Steps With the exception of films specifically labeled and made for exterior application, always install film on the interior of a window. Film applied to the exterior will easily fail due to exposure to the elements.

Unless your film has been pre-cut to the exact glass size, measure your glass at the top and bottom to ensure accuracy. Lay your film flat and cut it to your required size. If you prefer you can cut the film over size and trim on the glass. Translucent clear embossed vinyl film. Light is refracted in different directions creating the effect of scattered lights. The small squares are 6mm x 6mm. Ideal for obscuring direct visibility and allows good light transmission.

Please note all doors (External & Internal) & any window that isa within300mmof any dooror within 800mm of the finished floor level must be toughened or safety glass. Take the stress out of DIY. Each design is simple and easy to install - just ask our customers! Read more Thoroughly spray and soak the glass surface AND the adhesive side of the film with the water mixture. Wetter is better! There is no such thing as too much water. The water will allow you to easily apply and reposition the film before you squeegee—and any excess water will evaporate as the film fully adheres. SX-SC700 easyfit 3D Bars is an striped, lightly textured static cling film with 3/16” frosted holographic lines. It provides obscured visibility and excellent light transmission.